LS Industrial Systems iG5A - Operation Keys

1. Basic Checklist
11
 Operation Keys
The following table lists the names and functions of the keypad’s operation keys.
Key
Name
Description
[RUN] Key
Used to run the inverter (inputs a RUN command).
[STOP/RESET]
Key
STOP: stops the inverter.
RESET: resets the inverter following fault or failure condition.
[▲] Key, [▼] Key
Switch between codes, or to increase or decrease parameter
values.
[◀] Key, [▶] Key
Switch between groups, or to move the cursor during parameter
setup or modification.
[ENT] Key
Used to select, confirm, or save a parameter value.
Caution
Install a separate emergency stop switch in the circuit. The [STOP/RESET] key on the keypad works
only when the inverter has been configured to accept an input from the keypad.