LS Industrial Systems iG5A - Fault Trip Monitoring

1. Basic Checklist
15
1.4 Fault Trip Monitoring
The following example demonstrates how to monitor fault trip conditions in the Operation group using the
keypad.
Step
Instruction
Keypad Display
1
Refer to the example keypad display.
An over current trip fault has occurred.
2
Press the [ENT] key, and then the [▲] key.
The operation frequency at the time of the fault (30.00Hz) is
displayed.
3
Press the [▲] key.
The output current at the time of the fault (5.0A) is displayed.
4
Press the [▲] key.
The operation status at the time of the fault is displayed. ACC on the
display indicates that the fault occurred during acceleration.
5
Press the [STOP/RESET] key.
The inverter resets and the fault condition is cleared. The frequency
reference is displayed on the keypad.
Over Current
Trip