3
Introduction
Manual Composition
1.1 Before You Think It Is Failure
1.2 Basic Operations
1.3 Parameter Change
1.3.1Carrier Frequency Change
1.3.2Initializing All Parameters
1.3.3Read and Write Parameters
1.4 Fault Trip Monitoring
2.1 Trips and Warnings
2.1.1Fault/Warning List
2.1.2Troubleshooting Fault Trips
2.2 Troubleshooting Other Faults
3.1 Regular Inspection Lists
3.1.1Daily Inspections
3.1.2Annual inspections
3.1.3Bi-annual Inspections
3.1.4Checking the Input/Output Modules
3.1.5 Replacement of the cooling fan
3.2 Storage and disposal
3.2.1Storage
3.2.2Disposal
There are troubleshooting fault trips &
other faults in these pages.
If problems are not resolved, please
contact your vendor or LSIS.
There are the regular inspection
lists in these pages.
When the problem of inverter occur,
please check the input/output
module that is basic hardware
check method.
When the problem of inverter occur,
you can check the basic checklist
before you think it is failure in these
pages.
check the set-up of parameter using
basic operations first and then
check the trip record.
1 Basic Checklist
Basic Checklist
To Next Page
Loading...
