When Break control, if rating current flows below than set
value, cut off the output without break open.
Break open current is not flow
any more
Check the Motor Capacity & Wiring
Displayed when user-setting parameters fails to be
entered into memory.
Displayed when an error occurs in the control circuitry of
the inverter.
Displayed when the inverter cannot communicate with
the keypad.
Displayed after Inverter resets keypad when keypad
error occurs and this status is maintained for a certain
time.
When NTC is not connected, outputs are cut off.
Need to inspect hardware.
Contact the retailer or the LSIS customer service center.
To Next Page
Loading...
