LS Industrial Systems iG5A - Parameter Change; Carrier Frequency Change

1. Basic Checklist
12
1.3 Parameter Change
1.3.1 Carrier Frequency Change
The following example demonstrates how to configure Carrier Frequency by modifying code H39(Carrier
Frequency) in the Function group 2 from 5.00(Hz) to 10.00(Hz). You can configure the parameters for
different codes in any other group in exactly the same way.
Step
Instruction
Keypad Display
1
Go to code H39(Carrier Frequency) in the Function group 2.
2
Press the [ENT] key.
The current Carrier Frequency value (5.00) for code H39 is displayed.
3
Press the [◀] key 2 times to move to the 1s place value.
Number ‘5’ at the 1s place position will flash.
4
Press the [▲] key to change the value to ‘0’ to match the 1s place
value of the target value’10.00’, Press the [◀] key to change the value
to ‘1’ to match the 10s place value of the target value’10.00’ , and then
press the [ENT] key.
All parameter digits will flash on the display.
5
Press the [ENT] key once again to save the changes.
Code H39 will be displayed. The parameter change has been
completed.