ASSEMBLY
OM 0467SB-A [12]
SNOWBLOWER ASSEMBLY
The snowblower is pre-assembled at the factory; however, parts in the bag and box must be assembled.
Use the present manual and lay out all parts for assembly. Separate bolts and nuts into various sizes.
After assembly, torque all the bolts according to the "Torque Specification Table" enclosed at the end of
the manual.
Preparation
Remove the lawnmower and the front loader if equipped from the tractor by following the
instruction in the tractor's operator's manual.
IMPORTANT: The front loader and subframe should never be installed simultaneously on
the tractor.
WARNING: To avoid
serious personal injury or
death
: Read and understand
the SAFETY INFORMATION
on the previous pages before
installation and operation
Perform all the assembly with
the unit properly blocked and
supported.
WARNING: To avoid
serious personal injury or
death: Park the tractor on level
ground, place the transmission
in neutral, set the parking
brake, disengage the drive
system, put all levers to
neutral, shut off the engine,
remove the ignition key and
wait for all movement to stop
BEFORE starting installation.