OPERATION
OM 0467SB-A [22]
ADJUSTMENTS
WARNING
To avoid serious personal injury or death:
Make sure tractor engine and snowblower
come to a complete stop and tractor drive
mechanism is disengaged BEFORE making
any adjustments.
Deflector Adjustment
The deflector angle must be set according to the
distance the snow must be thrown. To adjust the
angle:
• Turn the chute to the right as far as possible.
• Loosen the two deflector knobs on the side
and adjust the deflector at the appropriate
angle.
• Tighten the knobs.
Skid Shoe Adjustment
(Figure 14)
Adjust the snowblower so that the skid shoes run
level and according to the surface conditions so
that stones are not thrown with the snow. Make
sure the skid shoes are at the same height to keep
cutting edge leveled.
To adjust skid shoe height (item 1) remove the two
carriage bolts, flat washers and nuts (items 2-3- 4).
Select the distance of the cutting edge based on
the unevenness of the surface either in position
"B" or "C". Tighten bolts securely.
Clearance between cutting edge and surface:
• POSITION A: Level paved surface.
• POSITION B & C: Uneven or gravel surface.
Fi
ure 14
To Next Page
