OPERATION
OM 0467SB-A [21]
OPERATION
Engine Speed
1. Start the tractor engine. Let the engine warm
up at least one minute before engaging the
drive mechanism then increase speed
gradually.
2. Make sure the snowblower head is properly
positioned and engage the drive mechanism.
3. Adjust the ground speed according to conditions.
For maximum power, run engine at or near full
throttle.
IMPORTANT: Use full RPM power when
removing wet, sticky snow. Low RPM power
will tend to clog the chute.
Lift Control
For detailed information on hydraulic lift controls,
refer to the tractor and / or subframe User Manual.
Increasing Traction and Stability
Make sure the tractor has counterweights as
recommended by your dealer. Weights provide the
balance needed to prevent rollover, loss of traction
or steering.
Engaging the Drive Mechanism
Refer to the tractor's operating manual for
instructions.
To Next Page
