ASSEMBLY
OM 0467SB-A [17]
PROCEDURE TO FOLLOW TO CONNECT THE SNOWBLOWER
IT'S IMPORTANT TO FOLLOW THESE STEPS IN THE ORDER INDICATED.
Step 1
Figure 8 : Start the tractor, remove the parking
brake and advance slowly making sure to align the
equipment female hitch with the male hitch of the
tractor. Lower the tractor male hitch enough so the
two upper hooks (item 1A) can be inserted in the
openings of the female hitch (item 2A).
Step 2
Figure 8: With the hydraulic control lever, raise
the equipment completely to correctly position the
equipment hitch with the tractor hitch. This will
make it possible for the male hitch bushings
(item 1B) to properly align with the female hitch
bushings (item 2B).
WARNING: To avoid serious injuries or
death: always engage the lock of the tractor
control lever, set the parking brake et turn off
the engine before stepping down from the
tractor to connect or disconnect the
equipment.
Step 3
Figure 9: Insert the two equipment hitch pins
(item 8) in the bushings (item 9) and secure with
the 1/4" round wire lock pins (item 10).
Step 4
Figure 9: Remove the "U" support (item 11)
holding the equipment driveline and attach it to the
welded pins (item 12) in the opposite direction
(upwards) with the two 2.5mm x 40mm hairpins
(item 13).
IMPORTANT: The hairpins (item 13) must be in
the position shown in Figure 9a.
Figure 8
Figure 9
Figure 9a
To Next Page
