OPERATION
OM 0467SB-A [20]
GENERAL PREPARATION
1. Read the operator's manual carefully before
using the tractor and snowblower. Be
thoroughly familiar with the controls and
proper use of the equipment. Know how to
stop the unit and disengage the controls
quickly.
2. Wear adequate winter outer garments while
operating the equipment.
3. Make sure the snowblower is clear of snow
and other material before engaging the
snowblower.
4. Make sure the auger and fan operate freely.
5. Check the oil level in the reduction box and if
necessary, add AGMA 5EP, SAE 80W90 gear
oil or equivalent.
6. Check the three shear bolts, one on each
auger section and one between the fan and
gearbox for proper tightness.
7. Adjust the skid shoes so the snowblower runs
leveled.
8. Before engaging the snowblower drive, always
have the engine running at idle.
9. Operate the snowblower at maximum engine
RPM.
WARNING: To avoid serious personal
injury: Do not use your hands to unclog the
chute. Use a 36" (925mm) stick or board. Do
not attempt to unclog the chute while engine is
running. If the chute is clogged, shut off the
tractor engine, remove the key and clear the
snow from the chute.
WARNING: To avoid serious
injurious or death:
• Never allow anyone near the work area.
• Never allow anyone to climb on the
equipment or the subframe.
• Before cleaning, adjusting or repairing the
equipment or subframe, immobilize the
tractor, wait for the complete stop of the
moving parts, set the parking brake, lower the
equipment to the ground, shut off the engine
and remove the ignition key.
• Never place any part of your body under the
equipment when making adjustments.
WARNING
Always operate the equipment from the tractor
seat. Never allow anyone to climb on the
machine.
WARNING
Operate the equipment at a speed that
corresponds to the work area conditions. Be
careful when working near a slope or on
uneven ground.
WARNING
Always wear safety glasses when operating
the equipment.
To Next Page
Loading...
