(6) Notices when transporting the tractor
When transporting the tractor by truck, trailer,
etc, use suitable equipment or facilities to
load or unload the tractor.
Fix the tractor tightly to the vehicle with heavy-
duty straps or chains.
When fixing the rear of the tractor, use the hitch
or hitch support.
When fixing the front of the tractor, use the
towing hook.
When driving on public roads, the transporting
vehicle must have signs and lights required by
(7) Notices when parking tractor
Stop the tractor on level ground. Place the
transmission gear in neutral.
Put PTO switch to “OFF” and lower implements to
the ground.
Stop the engine and remove the ignition key.
vehicle must have signs and lights required by
local regulation to avoid collision with a vehicle.
▶
When fixing the tractor, Do not hook or connect chains to the 4WD shaft, steering
cylinder, tie-rod or front axle. These can be damaged by the chain or excessive
strain.
▶
In case of turbocharger engine (where fitted), cover the exhaust outlet to protect
that the turbocharger does not rotate by air without lubrication.
Caution
1
1 1
1 - 9
Have to apply the wheel chock on a slope.
▶
When parking on a slope while attaching the loaded equipment, the tractor may
move even if the parking brake is applied. Apply the wheel chock and low speed
transmission gear as follow.
-. Mechanical : downhill
⇒
Reverse 1gear / uphill
⇒
Forward 1gear
-. HST type : Lowest gear
-. EZ-Shift (AMT) : Engaging gear as mechanical type, BEFORE TURNING OFF
THE KEY SWITCH.
Caution
To Next Page
Loading...
Need help?
General
