HST type
Position control lever
1. Pull the position control lever
back to lift the implement up after
starting engine.
2. Set the engine speed more than
1500 rev/min.
3. Place the range gear shift lever
in desired position.
5. Press the brake pedal and
release the parking brake lever.
5. Press the HST pedal slowly
forward or backward to move the
tractor.
Brake pedal
4WD lever
HST reverse
pedal
Range gear
shift lever
Throttle lever
Differential
lock pedal
Parking brake
lever
HST forward
pedal
4
4 4
4 - 5
▶
If you press the brake pedal or push down the cruise control lever, the cruise
control drive shall be stopped.
▶
For HST model, there is a switch to control engine cut-off for driver’s safety. If the
operator leaves the driver’s seat without proper action for safety, the engine shall be
stop automatically. (For further information about seat, see page 3-14)
▶
When driving or working with a tractor, operate it more than 1500 rev/min.
▶
Press the HST forward / reverse pedal slowly. If you depress the HST forward /
reverse pedal hastily, It might start suddenly.
6. If necessary, pull the cruise
control lever up for constant driving
speed.
Caution
PTO gear
lever (if fitted)
To Next Page
Loading...
