9.3 Monitoring Connection Status of External Storage Equipment
XGT Panels monitors connection status about external storage equipment designated when setting backup path
in XP-Builder.
The following figure is backup path specified in XP-Builder.
In order to use this monitoring function, you have to set about system alarm window, and then the project should
be downloaded.
In case USB storage equipment is removed during operation after setting the path for saving Logging backup file
as USB storage equipment and downloading the project into device, the designated system alarm (HS951.0) is
set. In case storage equipment is equipped again, alarm is reset.
In case USB storage equipment is removed during operation after setting the path for saving Recipe backup file
To Next Page
Loading...
