12.1.2 KC standard certification
The XGT Panel acquire the electromagnetic fitness registration (KC specification) certified by wave laboratory
under information-communication part.
A grade device
This device acquires KC for industrial use.
If device is not purchased properly, exchange it to device for home use.
12.2 Requirement for Low Voltage Command Suitability
It is required to get the needed Stability for the device operated at AC50~1000V, DC75~1500V’s power. The
following describes attention about installation and wiring for the suitability when using the XGT Panel. Though
the following data is made by requirement of regulation and standard, we don’t guarantee that all devices are
suitable for the above command. The method to be suitable for the EMC command and judgment of suitability
should be finally made by device manufacturer himself.
12.2.1 Standard certification for XGT Panel
XGT Panel is according to the EN61131-2:2007 (stability of device used in the measure, control laboratory).
12.2.2 Selection of XGT Panel
(1) eXP20-TTA/DC, eXP20-TTA/DC,CERTI, eXP30-TTA(B)/DC, eXP30-TTE/DC, eXP40-TTA(B)/DC,
eXP40-TTE/DC, eXP60-TTA(B)/DC
The I/O module under DC24V exceeds the range of low voltage command target.
To Next Page
Loading...
