Page 8 of 35
1.4 Safety precautions
Whilst the autoclave has built-in safety devices, their operation may be impaired if the
autoclave is not used correctly and in accordance with the instructions. In addition, it is
important to observe the following safety rules at all times:
• wait until the cycle is complete and the machine is cool before attempting to unload
• beware of residual steam in the chamber and hot surfaces when the door is opened
at the end of a cycle
• wear an overall or lab coat, gloves and safety glasses to protect hands, arms and
eyes when loading or unloading the chamber, since the load temperature may be as
high as 100
o
C
• when moving the autoclave, for example during installation, remember that its
weight can make it dangerous if not handled carefully
• ensure that the earth or ground of the power supply cable is connected to a suitable
protective earth supply, and that the supply lines are correctly fused and isolated
• if the plastic bottle for discharge collection has been connected to the autoclave’s
drain system, then in order to avoid being scalded by hot water or steam:
o
do not try to empty the bottle while a cycle is in operation
o
do not run the autoclave with the drain disconnected from the bottle.
To Next Page
Loading...
