2. Secure the mounting plate on the gang box with the 4 supplied screws (SC-KA4X25). Remove
the back cover and route the cable through the cable hole, wire the cables and insert the cables
in the gang box.
3. Align the device with the mounting plate, and secure the device on the mounting plate with 1
supplied screw (SC-M3X8NL-SUS316L-GB78).
Figure 3-3 Surface Mounting
3.3 Flush Mounting
Steps
1. Make sure the gang box is installed on the wall.
2. Secure the mounting plate on the gang box with the four supplied screws (SC-KA4X25).
3. Remove the back cover and route the cable through the cable hole, wire the cables and insert
the cables in the gang box.
To Next Page
Loading...
