Server Address Type/Server Address/NTP Port/Interval
You can set the server address type, server address, NTP port, and interval.
DST Settings
Enable DST.
Set the DST start time, end time and bias time.
Click Next to complete the settings.
7.4 Environment Settings
After activating the device, you should select an application mode for better device application.
Steps
1. Click → Environment Settings.
2. Select Indoor or Other.
Note
● If you install the device indoors near the window or the face recognition function is not
working well, select Others.
● If you do not configure the application mode and tap Next, the system will select Indoor by
default.
● If you activate the device via other tools remotely, the system will select Indoor as the
application mode by default.
Click Next to complete the settings.
7.5 Administrator Settings
Steps
1. Click in the top right of the web page to enter the wizard page. After setting device
language, time, environment and privacy, you can click Next to enter the Administrator Settings
page.
2. Enter the employee ID and name of the administrator.
3. Select a credential to add.
Note
You should select at least one credential.
1) Click Add Face to upload a face picture from local storage.
To Next Page
Loading...
