Note
● 6 to 12 letters (a to z, A to Z) or numbers (0 to 9), case sensitive. You are recommended to
use a combination of no less than 8 letters or numbers.
● The verification code cannot be 123456 or abcdef (case non-sensitive0).
5. Click Save to enable the settings.
Device Access Setting
Steps
1. Click Configuration → Network → Device Access → SIP to enter the settings page.
2. Check Enable VOIP Gateway.
3. Configure the SIP parameters.
4. Click Save to enable the settings.
5. Click Configuration → Network → Device Access → SDK Server to enter the settings page.
6. Set the Server Port. It refers to the port through which the client adds the device.
8.6.9 Set Video and Audio Parameters
Set the image quality and resolution.
Set Video Parameters
Click Configuration → Video/Audio → Video.
Figure 8-5 Video Settings Page
Set the stream type, the video type, the resolution, the bitrate type, the video quality, the frame
rate, the Max. bitrate, the video encoding, and I Frame Interval.
Click Save to save the settings after the configuration.
To Next Page
Loading...
