8.6 Configuration
8.6.1 Set Local Parameters
Set the live view parameters, picture, and clip settings.
Set Live View Parameters
Click Configuration → Local to enter the Local page. Configure the stream type, the play
performance and click Save.
Picture and Clip Settings
Click Configuration → Local to enter the Local page. Select image format, saving path and click
Save.
You can also click Open to open the file folder to view details.
8.6.2 View Device Information
View the device name, device No., system type, language, model, serial No., version, number of
channels, IO input, RS-485, register number, alarm input, alarm output, and device capacity, etc.
Click Configuration → System → System Settings → Basic Information to enter the configuration
page.
You can view the device name, device No., system type, language, model, serial No., version,
number of channels, IO input, RS-485, register number, alarm input, alarm output, and device
capacity, etc.
8.6.3 Set Time
Set the device's time, time zone, synchronization mode, server address, NTP port, and interval.
Click Configuration → System → System Settings → Time Settings.
Click Save to save the settings after the configuration.
Time Zone
Select the device located time zone from the drop-down list.
Time Sync.
NTP
You should set the NTP server's IP address, port No., and interval.
Manual
By default, the device time should be synchronized manually. You can set the device time
manually or check Sync. with Computer Time to synchronize the device time with the
computer's time.
To Next Page
Loading...
