Server Address Type/Server Address/NTP Port/Interval
You can set the server address type, server address, NTP port, and interval.
8.6.4 Set DST
Steps
1. Click Configuration → System → System Settings → Time Settings.
2. Enable DST.
3. Set the DST start time, end time and bias time.
4. Click Save to save the settings.
8.6.5 Change Administrator's Password
Steps
1. Click Configuration → System → User Management.
2. Click .
3. Enter the old password and create a new password.
4. Confirm the new password.
5. Click Save.
Caution
The password strength of the device can be automatically checked. We highly recommend you
change the password of your own choosing (using a minimum of 8 characters, including at least
three kinds of following categories: upper case letters, lower case letters, numbers, and special
characters) in order to increase the security of your product. And we recommend you change
your password regularly, especially in the high security system, changing the password monthly
or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
8.6.6 Online Users
The information of users logging into the device is shown.
Go to Configuration → System → User Management → Online Users to view the list of online
users.
8.6.7 View Device Arming/Disarming Information
View device arming type and arming IP address.
Go to Configuration → User Management → Arming/Disarming Information.
To Next Page
Loading...
