LTS LTH-401M-WIFI - Event Linkage Configuration; Access Control Settings; Set Authentication Parameters

3. Click Modify to edit the arming schedule.
4. Click on the time bar and drag to select the time period. Click Save to save the settings.
5. Click to enable Notify Security Center.
Note
Send an exception or alarm signal to the remote management software when an event occurs.
6. Click Save to enable the settings.
8.6.12 Event Linkage
Set linked actions for events.
Steps
1. Click Configuration → Event → Event Detection → Linkage Settings to enter the page.
Figure 8-9 Event Linkage
2. Select device event or door event.
3. Click to enable or disable Notify Security Center for event.
Note
Send an exception or alarm signal to the remote management software when an event occurs.
8.6.13 Access Control Settings
Set Authentication Parameters
Click Configuration → Access Control → Authentication Settings.
Note
The functions vary according to different models. Refers to the actual device for details.