Figure 8-10 Set Authentication Parameters
Terminal
Terminal description is read-only.
Continuous Face Recognition Interval
You can set the interval between 2 continuous recognition of a same person during the
authentication. In the configured interval, Person A can only recognized once. If another person
(Person B) has recognized during the interval, Person A can recognized again.
Note
The interval ranges from 1 s to 10 s.
Click Save to save the settings after the configuration.
Set Door Parameters
Click Configuration → Access Control → Door Parameters.
Door No.
Select the device corresponded door No.
Door Name
You can create a name for the door.
Open Duration
Set the door unlocking duration. If the door is not opened for the set time, the door will be
locked.
Relay Reverse
Click to enable or disable relay reverse.
Enable QR Code Auth.
Click to enable or disable QR Code Authentication.
Enable Face Auth.
Click to enable or disable face Authentication.
Click Save to save the settings after the configuration.
To Next Page
Loading...
