Elevator Control
Steps
1. Click Configuration → Access Control → Elevator Control Parameters.
Figure 8-11 Access Control and Elevator Control
2. Click to enable Elevator Control.
3. Set the elevator parameters.
Elevator No.
Select an elevator No.
Main Elevator Controller Model
Select an elevator controller.
Interface Type
If you select RS-485, make sure you have connected the device to the elevator controller with
RS-485 wire.
If you select Network Interface, enter the elevator controller's IP address, port No., user
name, and password for communication.
Negative Floor Capacity
Set the negative floor number.
Note
● Up to 4 elevator controllers can be connected to 1 device.
● Up to 10 negative floors can be added.
● Make sure the interface types of elevator controllers, which are connected to the same
device, are consistent.
To Next Page
Loading...
