Lucent Technologies CBX 500 - Page 229

CBX 500 Multiservice WAN Switch Hardware Installation Guide 4/5/03Index-5
Index
R
Rack-mounting the unit, 4-8
Radio frequency interference. See
Regulatory information
Redundancy, D-3 to D-8
configuring IOA modules, D-3
configuring IOP modules, D-3
configuring SP modules, D-3
failure of active module, D-3
keep-alive mechanism, D-6, D-7
NMS, D-8
overview, D-3
slot assignments for redundant pairs, D-2
switch changeover, D-5
Redundancy Manager, D-5
Regulatory information, C-2
BSMI statement, C-8
Canadian requirements, C-3
FCC and Telco, C-7
FCC Part 68, C-5
VCCI statement, C-8
Request For Comment (RFC)
standards supported, A-7
RFC. See Request For Comment
RJ48
specifications and cabling requirements,
A-7
S
Safety warnings, 2-5
Shielded cable requirements, A-8
Signal levels
8-port subrate, A-41
IMA IOM, A-47
Single-mode (OC12/STM)
long-reach, A-32
medium-reach, A-32
Single-mode (OC3/STM)
long-reach, A-27
medium-reach, A-27
SP adapter module. See SPA module
SP module
configuring for redundancy, D-3
description, 1-5
features, 1-7
hot swapping, 6-3
installing, 6-5
installing and replacing, 6-3
LEDs, 7-3
models, 1-7
redundancy, 1-7
removing, 6-3
replacing SPA, 6-8
SPA module, 1-5
location, 3-7
Specifications
1-port OC12/STM4 IOP, A-31
4-port ATM UNI OC3/STM IOP, A-25
4-port channelized DS3 Frame/IP IOP,
A-20
4-port Ethernet IOP, A-36
6-port DS3 Frame/IP IOP, A-16
8-port DS3/E3 ATM UNI IOP, A-11
8-port T1/E1 IOP, A-2
electrical, 2-2
environmental, 2-4
IMA IOM, A-45
physical, 2-3
space, 2-4