33
To select a personalized
ringing pattern (for those
8434DX voice terminals
which have a
button)
1 While on-hook, press
• Red light next to winks
• Current ringing pattern plays and repeats every
three seconds.
• The display shows the ringing pattern you are
hearing, such as:
2 Cycle through the ringing patterns by pressing (and
then releasing)
• Red light next to continues to wink
• The display shows the number of the ringing
pattern you have selected
Note: You can also press or ) to
cycle through all eight ringing patterns
3 If you want to save the ringing pattern currently
being played, don’t press anymore. You will hear
the selected ringing pattern two more times, and then
it will be automatically saved.
Ring
Ring
SELECT RING PATTERN: 1
Ring
Ring
Next
Prev
Ring
• You hear confirmation tone (two rising tones)
• Red light next to goes off
Note: If you receive a call, go off-hook, or lose power
during selection, the process is interrupted and you
must start again.
To adjust ringer volume
if necessary (handset and
speaker are not active, or
the handset and ringer
are both active)
1 To raise the volume, press the right half of the
Volume control button labeled ;
to lower the volume, press the left half of the
Volume control button labeled
Ring
To Next Page
Loading...
