30
Priority Calling
To place a priority call
(3-burst ring)
1 While off-hook, press and then press the softkey
below PCall
or Press (while off-hook)
or the Dial Priority Calling access code __________
(while off-hook) [dial tone]
2 Dial the extension [ringback tone]
• Wait for the called party to answer
To change a regular call
into a priority call
(3-burst ring) when you
hear a call waiting
ringback tone
1 Press and then press the softkey below PCall
or Press
• Called party receives a priority call-waiting tone
(3-burst ring)
2 Wait for the called party to answer
Note: If you still receive a call waiting ringback
tone, wait a few minutes and try again.
Menu
Priority
Menu
Priority
Important: You can use this feature only if the Reset Spkr label appears under the
button and the voice terminal is set for the Speakerphone feature.
If your 8434DX is equipped with this feature, you can adjust the speakerphone to
the surrounding room acoustics to provide optimal performance. Use the Reset
Speakerphone feature in the following ways:
• Whenever you move your voice terminal to another place (even in the same room)
• Whenever the red light next to is fluttering
Note: You may also use this feature when you are on a call in the unlikely event
your speakerphone makes a squealing noise during the call. Your speakerphone
will adjust itself to normal for that call. (No tones will be heard.)
Important: If there has been an interruption in power (such as, the system has
just been powered up again, or you have plugged in the voice terminal at another
location), the light next to flutters until you reset the built-in
speakerphone.
You can initiate the Reset Speakerphone feature when your handset is on-hook, or
during a call in which you are using the built-in speakerphone. (If a call is in
progress, you will not hear the tones, and the new speakerphone adjustment is reset
for only the duration of that call.)
Remember you can use the Reset Speakerphone feature only if your voice terminal is
set for the Speakerphone features (as opposed to the Speaker feature).
Reset Speakerphone
To Next Page
Loading...
Need help?
General
