PortMaster Software
1-6 Communications Server Hardware Installation Guide
To configure the PortMaster, you can use either of the following:
• Lucent’s Command Line Interface. If you are using the command line interface to
configure the PortMaster Communications Server, refer to the Command Line
Administrator’s Guide and the Configuration Guide for PortMaster Products for
instructions.
• Lucent’s PMconsole Software. PMconsole guides you through configuration using
a simple graphical user interface (GUI). It is available for Windows 95, Windows
NT 4.0 or later, and for many versions of UNIX. You can install PMconsole from
the PortMaster Software CD or from the Lucent Remote Access FTP site.
Refer to the PMconsole for Windows Administrator’s Guide for configuration
instructions.
Note – You must use the command line interface to configure certain ComOS features
such as the Open Shortest Path First (OSPF) protocol on the PortMaster
Communications Server.
PM-2i-U ComOS 3.3.1
PM-2i-ST ComOS 3.3.2
PM-2Ei-U ComOS 3.3.1
PM-2Ei-ST ComOS 3.3.2
MOD-2E Any ComOS release can be used.
MOD-10I-U ComOS 3.3.1
MOD-10I-ST ComOS 3.3.2
Ta b le 1 - 5 PortMaster Software Compatibility (Continued)
Product Earliest Compatible ComOS Release
✍
To Next Page
Loading...
