Log In
2-16 Communications Server Hardware Installation Guide
9. Log In
Follow these instructions to log in to the PortMaster.
1. From the login prompt, type !root and press the Enter key.
2. From the password prompt, press the Enter key—no password is needed.
10. Set the Network Address
Set an IP address and netmask for an IP network and/or an IPX network number and
frame type for an IPX network.
IP Address
Follow these instructions to set an IP address and netmask for the PortMaster.
From the command prompt, enter the following information, pressing the Enter key
after each line.
Replace the italicized values with values appropriate for your network.
login: !root
Password:
Command>
Command> set ether0 address 172.168.200.1
Command> set netmask 255.255.255.0
Command> save all
Command> quit
To Next Page
Loading...
Need help?
General