LK-T21 Technical Manual
Command Descriptions
Command Notation
[Name] The name of the control command.
[Format] The code sequence.
In this description, < > H denotes hexadecimal numbers, < >denotes
decimal numbers and < > B denotes binary numbers.
[ ] k indicates the contents of the [ ] should be repeated k times.
[Range] The allowable range for the arguments.
[Description] Description of the command function.
[Details] If necessary provides important information on setting and using the printer command.
[Default] The default values for the commands.
[Reference] List related commands.
[Example] Example of using the commands.
The numbers denoted by <>H is hexadecimal.
The numbers denoted by <>B is binary.
Print Commands
The WTP series supports the following commands for printing characters and advancing
paper.
HT
[Name] Horizontal tab
[Format] ASCII HT
Hex 09
Decimal 9
[Description] Moves the print position to the next tab position.
[Details] ·This command is ignored unless the next tab position has been set.
·If the next horizontal tab position exceeds the printing area, the printer
sets the printing position to [Printing area width + 1].
·Horizontal tab positions are set using “ESC D”.
·If this command is received when the printing position is at [printing area width +1], the printer
executes print buffer-full printing of the current line and horizontal tab processing from the
beginning of the next line.
·The default setting of the horizontal tab position for the paper roll is font A
(12 x 24) every 8th character (9th, 17th, 25th, … column).
[Reference] ESC D
21
To Next Page
Loading...