LK-T21 Technical Manual
[Name] Print and feed n lines
[Format] ASCII ESC d n
Hex 1B 64 n
Decimal 27 100 n
[Range] 0≤n ≤255
[Description] Prints the data in the print buffer and feeds n lines.
[Details] ·This command sets the print starting position to the beginning of the line
·This command does not affect the line spacing set by ESC 2 or ESC 3.
·The maximum paper feed amount is 1016 mm{40”}. If the paper feed
amount(n x line spacing) of more than 1016 mm{40”} is specified, the printer feeds the paper
only 1016 mm{40”}.
[Reference] ESC 2, ESC 3
ESC p m t1 t2
[Name] Generate pulse
[Format] ASCII ESC p m t1 t2
Hex 1B 70 m t1 t2
Decimal 27 112 m t1 t2
[Range] m = 0, 1, 48, 49
0≤t1 ≤255, 0≤t2 ≤255
[Description] Outputs the pulse specified by t1 and t2 to connector pin m as follows:
m Connector pin
0, 48 Drawer kick-out connector pin2.
1, 49 Drawer kick-out connector pin5.
[Details] ·The pulse ON time is [ t1 x 2 ms] and the OFF time is [ t2 x 2 ms].
·If t2 < t1, the OFF time is [ t1 x 2 ms]
[Reference] DLE DC4
ESC t n
50
To Next Page
Loading...