Lukhan LK-T21 - Paper Specifications; Near-end Sensor and Roll Diameter

To Next Page

To Previous Page

LK-T21 Technical Manual

2) Near-end sensor:

a) Detection method: Photo Reflector

b) Paper roll spool diameter:

Inside: 12mm(.47″)

Outside: 18mm(.71″)

c) Near-end adjustment: Adjusting screw

d) Remaining amount:

Fixed position #1 (approximately 23mm(0.9″))

#2 (approximately 27mm(1.06″))

NOTE: You can use a command to stop printing upon detection of a paper near-end.

1.5 Paper Specification

1) Paper type: Specified thermal paper

2) Form: Paper roll

3) Paper width:

(82.5mm paper width model)

82 ±0.5mm (3.23" ±0.02")

(80mm paper width model)

79.5 ±0.5mm (3.13" ±0.02")

(60mm paper width model)

59.5 ±0.5mm (2.34" ±0.02")

(58mm paper width model)

57.5 ±0.5mm (2.26" ±0.02")

4) Paper roll size: Roll diameter : Maximum 83mm

Take-up paper roll width:

80 ± 0.5, 1.0mm(3.15"±0.020", 0.04")

5) Paper roll spool diameter: Inside: 12mm(.47")

Outside: 18mm(.71")

NOTE: Paper must not be pasted to the paper roll spool.

1.6 Printable Area