LK-T21 Technical Manual
GS / m
[Name] Print down-loaded bit image
[Format] ASCII GS / m
Hex 1D 2F m
Decimal 29 47 m
[Range] 0 ≤ m ≤ 3,48 ≤ m ≤ 51
[Description] Prints a downloaded bit image using the mode specified by m.
m selects a mode from the table below:
m Mode Vertical Dot Density Horizontal Dot Density
0, 48 Normal 180 DPI 180 DPI
1, 49 Double-width 180 DPI 90 DPI
2, 50 Double-height 90 DPI 180 DPI
3, 51 Quadruple 90DPI 90 DPI
[dpi : dots per 25.4 mm {1”}]
[Details] ·This command is ignored if a downloaded bit image has not been defined.
·In standard mode, this command is effective only when the on data exists
in the print buffer.
·This command is not affected by print modes (emphasized, double-strike,
underline, or character size, white/black reverse printing), except for
upside down mode.
·If the downloaded bit-image to be printed exceeds the printable area, the
excess data is not printed.
·If the printing area width set by GS L and GS W is less than one line
vertical, the following processing is performed only on the line in
question:
① The printing area width is extended to the right up to one line in
vertical. In this case, printing does not exceed the printable area.
② If the printing area width cannot be extended by one line in vertical,
the left margin is reduced to accommodate one line in vertical.
[Reference] GS ∗
60
To Next Page
Loading...