LK-T21 Technical Manual
·This printable area for this printer is approximately 72.2 mm {512/180”}
in the horizontal direction and approximately 117.3 mm {1662/360”} in
the vertical direction.
[Default] xL = xH = yL = yH = 0
dxL = 0, dxH = 2, dyL =126, dyH = 6
[Reference] CAN, ESC L, ESC T, GS P
ESC ＼ nL nH
[Name] Set relative print position
[Format] ASCII ESC ＼ n
L nH
Hex 1B 5C nL nH
Decimal 27 92 nL nH
[Range] 0≤n
L≤255
0≤n
H≤255
[Description] Sets the print starting position based on the current position by using the horizontal or vertical
motion unit.
·This command sets the distance from the current position to [(n
L+ nH x 256) x (horizontal or
vertical unit)].
[Details] ·Any setting that exceeds the printable area is ignored.
·When pitch N is specified to the right :
n
L + nH x 256 = N
When pitch n is specified to the left (the negative direction), use the complement of 65536.
When pitch n is specified to the left : n
L + nH x 256 = 65536 – n.
·The print starting position moves from the current position to [n x horizontal or vertical motion
unit].
·The horizontal and vertical motion units are specified by GS P.
·The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement amount,
and it must be in even units of the minimum horizontal movement amount.
·In standard mode, the horizontal motion unit is used.
·In page mode, the horizontal or vertical motion unit differs as follows,
depending on the starting point of the printing area :
When the starting position is set to the upper left or lower right of the printable area using ①
ESC T, the horizontal motion unit (x) is used.
When the starting position is set to the upper right or lower left of the printable area using ②
ESC T, the vertical motion unit (y) is used.
[Reference] ESC $, GS P
46
To Next Page
Loading...