LK-T21 Technical Manual
DLE DC4 n m t
[Name] Generate pulse at real-time
[Format] ASCII DLE DC4 n m t
Hex 10 14 n m t
Decimal 16 20 n m t
[Range] n=1
m=0,1
1≤t≤8
[Description] Outputs the pulse specified by t to connector pin m as follows:
m Connector pin
0 Drawer kick-out connector pin 2.
1 Drawer kick-out connector pin 5.
The pulse ON time is [ t x 100 ms] and the OFF time is [ t x 100 ms].
[Details] ·When the printer is in an error status when this command is processed,
this command is ignored.
·When the pulse is output to the connector pin specified while ESC p or DEL DC4 is executed
while this command is processed, this command is ignored.
·The printer executes this command upon receiving it.
·This command is executed even when the printer is off-line, the receive buffer is full, or there is an
error status.
·If print data includes the same character strings as this command, the printer performs the same
operation specified by this command. The user must consider this.
·This command should not be used within the data sequence of another command that consists of
2 or more bytes.
·This command is effective even when the printer is disabled with ESC = (Select peripheral device).
[Reference] ESC p
ESC FF
[Name] Print data in page mode
[Format] ASCII ESC FF
Hex 1B 0C
Decimal 27 12
[Description] In page mode, prints all buffered data in the printable area collectively.
[Details] ·This command is enabled only in page mode.
·After printing, the printer does not clear the buffered data, setting value for ESC T and ESC W,
and the position for buffering character data.
[Reference] FF, ESC L, ESC S
26
To Next Page
Loading...