LK-T21 Technical Manual
GS $ nL nH
[Name] Set absolute vertical print position in page made
[Format] ASCII GS $ nL nH
Hex 1D 24 nL nH
Decimal 29 36 nL nH
[Range] 0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
[Description] · Sets the absolute vertical print starting position for buffer character data
in page mode.
·This command sets the absolute print position to [ (nL + nH ×256) × (vertical or horizontal
motion unit)] inches.
·If the [ (nL + nH × 256) × (vertical or horizontal motion unit)] exceeds the
specified printing area, this command is ignored.
·The horizontal starting buffer position does not move.
·The reference starting position is that specified by ESC T.
·This command operates as follows, depending on the starting position of the printing area
specified by ESC T:
When the starting position is set to the upper left or lower right, this ①
command sets the absolute position in the vertical direction.
When the starting position is set to the upper right or lower left, this ②
command sets the absolute position in the horizontal direction.
·The horizontal and vertical motion units are specified by GS P.
·The GS P command can change the horizontal and vertical motion unit.
However, the value cannot be less than the minimum horizontal movement amount, and it
must be in even units of the minimum horizontal movement amount.
[Reference] ESC $, ESC T, ESC W, ESC ＼, GS ＼, GS P
58
To Next Page
Loading...