LK-T21 Technical Manual
[Name] Select page mode
[Format] ASCII ESC L
Hex 1B 4C
Decimal 27 76
[Description] Switches from standard mode to page mode.
[Details] ·This command is enabled only when input at the beginning of a line in
standard mode.
·This command has no effect in page mode.
·After printing by FF is completed or by using ESC S, the printer returns to standard mode.
·This command sets the position where data is buffered to the position specified by ESC T within
the printing area defined by ESC W.
·This command is switches the setting for the following commands (in which the values can be
set independently in standard mode and page mode) to those for page mode.
Set right① -side character spacing : ESC SP, FS S
② Select default line spacing : ESC 2, ESC3
·Only valve settings is possible for the following commands in page
mode; these commands are not executed.
Turn 90① ° clockwise rotation mode on/off: ESC V
Select justification: ② ESC a
Turn upside③ -down printing mode on/off: ESC {
Set left margin: ④ GS L
Set printable area width: ⑤ GS W
·The following command is ignored in page mode:
Execute test print: ① GS W
·The following command is not available in page mode:
① Print NV bit image : FS p
② Define NV bit image : FS q
③ Print raster bit image : GS v 0
·The printer returns to standard mode when power is turned on, the printer is reset, or ESC @ is
used.
[Reference] FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS $, GS ＼
ESC M n
40
To Next Page
Loading...