LK-T21 Technical Manual
data as normal data.
·If the horizontal size exceeds printing area, the printer only feeds the paper.
·This command feeds as much paper as is required to print the bar code, regardless of the
line spacing specified by ESC 2 or ESC 3.
·This command is enabled only when on data exists in the print buffer.
When data exists in the print butter, the printer processes the data following m as normal data.
·After printing bar code, this command sets the print position to the beginning of the line.
·This command is not affected by print modes (emphasized, double-strike, underline,
character size, white/black reverse printing, or 90˚ rotated character, etc), except for upside-
down printing mode.
[Details in page made]
·This command develops bar coed data in the print buffer, but does not print it. After
processing bar cod data, this command moves the print position to the right side dot of the bar
code.
·If d is out of the specified rang, the printer stops command processing and processes the
following data as normal data. In this case, the data butter position does not change.
·If bar code width exceeds the printing area, the printer does not print the bar code but moves
the data buffer position to the left side out of the printing area.
·Refer to Figure 3.12.3 for bar code data buffer position.
When CODE93 (m=72) is used :
·The printer prints an HRI character (□)as start character at the
beginning of the HRI character string.
·The printer prints an HRI character(□)as a stop character at the end of
the HRI character string.
·The printer HRI characters (■+an alphabetic character) as a control
character(<00>H to <1F>H and <7F>H):
Control character Control character
ASCⅡ Decimal
HRI character
ASCⅡ Hex Decimal
HRI character
NUL 00 0 ■U DLE 10 16 ■P
SOH 01 1 ■A DC1 11 17 ■Q
STX 02 2 ■B DC2 12 18 ■R
ETX 03 3 ■C DC3 13 19 ■S
EOT 04 4 ■D DC4 14 20 ■T
ENQ 05 5 ■E NAK 15 21 ■U
ACK 06 6 ■F SYN 16 22 ■V
BEL 07 7 ■G ETB 17 23 ■W
BS 08 8 ■H CAN 18 24 ■X
HT 09 9 ■I EM 19 25 ■Y
LF 0A 10 ■J SUB 1A 26 ■Z
VT 0B 11 ■K ESC 1B 27 ■A
FF 0C 12 ■L FS 1C 28 ■B
CR 0D 13 ■M GS 1D 29 ■C
SO 0E 14 ■N RS 1E 30 ■D
SI 0F 15 ■0 US 1F 31 ■E
DEL 7F 127 ■T
Hex
73
To Next Page
Loading...