Cura LulzBot Edition
and print speeds. This will make the organic curves slightly more
step-like than the ne setting, but it will reduce printing time.
High Speed
Designed for the fast prints, where the overall model nish is not of
concern. Most commonly used for quick iteration of designs when
rapid prototyping.
Material Selection
We have the dierent laments separated by Material ease of use. From
the Material ease of use drop down, select "All" to view all our pre-
loaded lament slicing proles. The TAZ ships with a lament sample for
the rst print. Refer to the included Quick Start Guide for the proper
“First Run” settings.
Printing Support Material
The LulzBot TAZ 3D printer is able to print models that have angles
and overhangs, even without support material. This will depend on the
overhang distance and angle of your particular model le. Turn this option
on if your model could benet from support material.
Brim
Brim is used to increase surface area of the part you’re printing, thereby
ensuring proper part adhesion. This will print a single layer high edge
around the base of the part, helping rst layer adhesion and minimizing
warping.
Load Model File
Select the STL model you would like to print. Either use the Load Model
button or select File > Load Model. Once the le has been loaded, you
will see a 3D rendering of your object on the build platform. Select the
model to see the various options.
20
To Next Page
Loading...
