LulzBot TAZ 6 - Using 1.75 Mm Filament

5.4. USING 1.75MM FILAMENT
Glue stick/PVA Glue solution
While almost all 3D printing laments will adhere well to the PEI print
surface, Nylon, and Amphora
™
-based print adhesion can be improved with
the application of an unscented PVA glue solution/glue stick. Flexible
laments such as NinjaFlex
®
and SemiFlex
™
can adhere too well and can
be released easier from the PEI print surface with an application of an
unscented PVA glue solution/glue stick to the print surface prior to starting
the printing process.
5.4 Using 1.75mm filament
Your LulzBot TAZ 3D printer is set up to use 3mm plastic lament by
default and may be capable of printing 1.75mm lament with no hardware
modication. While many of our advanced users are able to do so, your
results may vary. More information can be found in our User Forums at:
https://forum.lulzbot.com/viewtopic.php?f=16&t=1923
71
PROOF