LulzBot TAZ 6 - Advanced Settings

3.6. ADVANCED SETTINGS
ever need to revert to the original factory settings navigate to Control ->
Restore Failsafe. Clicking Restore to Factory will set all conguration
settings back to the original factory settings in the rmware.
For more information on the conguration settings please see the
LulzBot TAZ support page at LulzBot.com/support.
3.6 Advanced Settings
In the advanced settings, you can control/modify your Z oset, maximum
velocity, acceleration, jerk, and esteps/mm. Once again we highly suggest
you not modify the conguration settings unless you are certain it is
necessary. Making incorrect adjustments of these settings can have adverse
aects on your prints, and potentially damage your machine.
Z Offset
Your LulzBot TAZ 3D printer has the ability to change the rst layer height
(Z oset) directly through the GLCD, even while printing the rst layer.
Using the GLCD, navigate to Configuration -> Advanced Settings ->
Z Offset. While in this screen you can rotate the GLCD knob counter-
clockwise to bring your nozzle closer to the print surface, and rotate it
clockwise to bring it farther away from the bed. Push in the GLCD knob
to save your settings.
61
PROOF