Cura LulzBot Edition
GCODE and choose the SD card location to save your GCODE le to your
SD card. Safely eject the card from the computer, and insert it into the
Graphical LCD Controller.
Start Print
Thanks to the TAZ automatic bed leveling system, it is now time to kick o
the print! Through the LCD screen go to: Print From SD > Desired File.
Your TAZ will then go through it’s automatic cleaning and wiping process
before starting the print. This should take approximately 5 minutes.
Printing from USB Cable
Connect your 3D printer to a computer using a USB cable, power it on
and select the Control button at the top of the 3D viewing window. If the
control button is not present, be sure you have a model le loaded into Cura.
If a model is loaded but the Control button is still not present use a dierent
USB cable, reinstall Cura, or contact our Support Team. This will bring
up your Printer Interface. You will not be able to send any commands until
the window title changes to Operational. Once operational, you can start
your rst print. Your TAZ will then go through it’s automatic cleaning and
wiping process before starting the print. This should take approximately 5
minutes.
28
To Next Page
Loading...
