Cura LulzBot Edition
Printing Temperature
This is where you will set the hot end temperature for your specic material.
It will be preset when using the recommended quickprint proles. This can
be adjusted for ne tuning of dierent lament manufacturers to help layer
adhesion or stringing. See Recommended Temperatures Table: page 30.
Your hot end is capable of reaching a maximum temperature of 300°C.
Bed Temperature
This is where you will set the print surface temperature for your specic
material. These will be preset when using the recommended quickprint
proles. This can be adjusted for ne tuning of dierent lament manufac-
turers to help adhesion or release. See Recommended Temperatures Table:
page 30. Your print surface is capable of reaching a maximum temperature
of 125°C.
Support Type
Some models will require support material in order to print properly. This
will usually occur when an object has an angle in relation to the build plate
between 0 to 45 degrees. It is highly recommended to orient your object so
that it minimizes or eliminates the need for support.
Touching Buildplate
This causes the support material to build up between the heated bed and
the object. The red example is Touching Buildplate.
Everywhere
This prints support material between the heated bed and object as well as
between the object and itself. The green example is Support Everywhere.
34
To Next Page
Loading...
