3.6. ADVANCED SETTINGS
Vmin
This sets the minimum overall speeds. We have this set to 0 by default to
allow greater control through your preferred slicing program.
VTrav Min
This will set the minimum travel speed when the tool head is not extruding.
We have this set to 0 by default to allow greater control through your
preferred slicing program.
Amax
The Amax settings will allow you to dene a maximum acceleration limit
for each motor. Increasing these may reduce print time, but can result in
in shadowing and resonance issues.
A-Retract
This sets the maximum acceleration for retraction moves of the extruder.
Going too high can lead to stripping, and going too low can lead to dripping.
We have this set to 3000mm/s
2
by default.
Steps/mm
Your LulzBot TAZ 3D printer is factory calibrated on all axis for accurate
movement. These settings control that movement, and if adjusted your
objects will not come out at the proper dimensions. We only recommend
adjusting your Esteps/mm as this can be ne tuned for individual tool
heads and laments.
63
To Next Page
Loading...
