GLOSSARY
RAMBo [R]epRap [A)]duino-[M]ega compatible [M]other [Bo]ard. Designed
by Joynnyr of UltiMachine.
Resolution In general terms, the resolution you print at can be determined
by the layer height you use. The LulzBot TAZ can print at a layer height
of 0.05mm to 0.50mm.
Slic3r Slic3r is a cross-platform 3D model slicing engine. It’s used to process
the 3 dimensional model into the GCODE (tool path) needed to physically
generate the print.
Spool Plastic lament coiled and stored on a plastic reel. Preferred over
1.75mm lament due to improved feeding and better mounting options.
Thermistor A special type of resistor that changes resistance based on
temperature. It is used to measure temperature on the nozzle and the
heated bed.
Threaded extension Used to separate the heater block and nozzle from
the PEEK insulator. The plastic lament passes through the threaded
extension into the melting chamber.
87
To Next Page
Loading...
