Rev #35 March 2024
Page 37 of 43
7.5 Saving flight on the USB stick
The last 20 flights will be downloaded at every switching on (only if the USB stick is inserted). If
there are already some of the 20 flights on the USB stick, they will not be downloaded again. That
means: if you have been flying a lot without downloading flights, the download procedure will take
some time, so don’t switch off. To download one flight after landing perform the following procedure:
Wait a 3 minute after landing. Then switch off power for at least 5 sec. Insert the USB stick (in case
it’s not already inside) and switch on again.
The collision avoidance functionality does not depend on the status of the USB stick
(inserted or not)
7.6 Updating the obstacle database
The firmware update will be executed, when the system finds a file with the extension *.obs. on
the USB stick root. The procedure runs identically to the firmware update and takes a few minutes.
Please delete the obstacle file from the USB stick after the update.
All data must be in the USB stick root directory. Folders and subfolder are not allowed. Names of
the files shall not be changed.
Loading new obstacle database will overwrite the old obstacle database
File format FAT16 or FAT32 and USB 2.0 type is supported.
FLARM Tools is used only for Classic FLARM and in not compatible with
PowerMouse.
Obstacle database can be purchased on official Flarm web site www.flarm.com, section
products/obstacles.
Under manufacturer, please select LXNAV
For device, please select PowerMouse.
To Next Page
Loading...
