Rev #35 March 2024
Page 39 of 43
7.7 Declaring tasks
Flarmcfg.txt files can also contain task declaration.
You can declare the task on PowerMouse in three possible ways:
• If connected to S8x/10x vario from the vario
• If connected to LX80xx/90xx system from the unit
• Via USB stick
In order to declare task via USB stick you will need PowerFlarmConfig software already mentioned
in previous chapters.
To declare task, go under “Declaration” and define pilots and airplanes parameters. By pressing
“Load” button you upload the .cup waypoint file from which you can then select points for flight
declaration. After you are done editing you save and transfer the file to the device the same way as
described in chapter 6.2.1.
To Next Page
Loading...
