19
ENGLISH
dealer programs this key code in the MPEM or ECU of your snowmobile to allow
engine operation above 3000 RPM if and only if this unique code has been read
after engine starting.
If a tether cord cap with different code is installed, the engine will start but cannot
reach drive pulley engagement speed to move vehicle.
Additional Tether Cord Caps
The MPEM/ECU of your snowmobile can be programmed by your authorized
Lynx dealer to accept 8 different key codes (tether cord caps).
DESS Pilot Lamp Codes
DESS pilot lamp blinking slowly (one time per 1,5 second) means that a bad
connection has been detected. Vehicle can not be driven.
To check for bad connection, remove tether cord cap. Make sure the tether cord
cap is free of dirt or snow. Reinstall cap and restart engine. If a blink still occurs,
contact an authorized dealer.
1. Free of dirt and snow
A DESS pilot lamp blinking 3 times per second means that you have installed a
cap with a code that MPEM of this snowmobile was not programmed to recogni-
ze (wrong key). Vehicle can not be driven.
11. DESS pilot lamp
This lamp will light up to confirm DESS status. Refer to previous paragraphs for
description.
12. Engine cut-out switch
This push-pull type or toggle type switch is located on the right side of the hand-
lebar. To stop the engine in an emergency, select OFF position and simulta-
neously apply the brake. To restart, button must be at the ON position.
To Next Page
Loading...
Need help?
General
