12
ENGLISH
Timer operation
NOTE! Before the timer is set must the vehicle be power up
After having selected the timer by pressing the MODE key (power on of the
TIMER writing on the on the left side of the display) it is possible to start timing
the hours, minutes and seconds by pressing the SET key; if 23 hours 59 minu-
tes and 59 seconds are reached the timer automatically starts counting again
from 00.00.00. the timing can be blocked by pressing the SET key while the
MODE key has a triple function:
1) If it is pressed while the timer has been activated, it allows you to visualize the
following setting (calendar).
2) If it is pressed while the timer has been blocked (with the SET key) with a
value different from
00:00:00 the timer can be reset.
3) If it is pressed while the timer is stopped at 00:00:00 it allows you to visualize
the following setting.
Using hours operation
NOTE! Before the using hours operation is set must the vehicle be power up
It is possible to visualize the using hours of the snow mobile with the Multi-
display; this setting is adjusted by the following conditions:
1) The increase of the hours is directly connected to the powering of the Multi-
display.
2) The using hours can be voided only if the default procedures are strictly follo-
wed (see Default procedure section).
3) The using hours are visualized in complete hours (without minutes or seconds)
Thermometer operations
The Multi-display normally indicates the temperature in °C with a resolution of
1°C, however, it is also possible to select the visualization in °F by simply con-
necting pin no.1 and 5 of the 6-way DEUTSCH connector (NOTE! This operation
has to be carried out while the Multi-display is off). No calibration of the thermo-
meter is provided.
Fuel indicator
The fuel level is represented on the upper part of the display by means of 11
vertical lines.
In Yeti V-1300 and Yeti 600 models are one vertical line is approximate 4 liter
gasoline.
Default procedure
Default procedures aim to reset the using hours of the snow mobile;
a) Power the Multi-display by pressing the MODE and SET keys (no indica-
tions will show up on the display).
b) Keep pressing the keys (for about 20 seconds) until the indication dEF show
up on the display which stands for DEFAULT.
c) Release the keys: The Multi-display will go back to its normal working.
To Next Page
Loading...
Need help?
General
