46
ENGLISH
Fluid levels
It is recommended that the assistance of an authorized Lynx dealer be perio-
dically obtained on other components/systems not covered in this guide. Un-
less otherwise specified, engine must be cold and not running. The tether cord
cap must be removed for all maintenance procedures.
CAUTION: Vehicle must be on a level surface before checking any fluid levels.
Brake system
Check brake fluid in reservoir for proper level. Add fluid as required.
CAUTION: Use only DOT 4 brake fluid from a sealed container.
Brake fluid reservoir
1. Minimum
Chain case models: Check the oil level by removing dipstick. Oil level must be
between lower and upper marks.
NOTE:It is normal to find metallic particles stuck to dipstick magnet. If bigger
pieces of metal are found, see an authorized Lynx dealer.
Remove metal particles from magnet.
Refill up to upper mark using recommended oil.
NOTE:Do not use unrecommended other types of oil when servicing. Do not mix
synthetic oil with other types of oil.
WARNING!
To Next Page
Loading...
Need help?
General
