30
ENGLISH
Guidelines to adjust suspension
The best way to set up suspension, is to start from factory settings then customi-
ze each adjustment one at a time. Adjustments 2 through 6 are interrelated. It
may be necessary to to readjust center spring after adjusting front springs for
instance. Test run the snowmobile under the same conditions; trail, speed, snow,
driver riding position, etc. Change one adjustment and retest. Proceed methodi-
cally until you are satisfied.
NOTE:Whenever adjusting rear suspension, check track tension and adjust as
necessary.
Slight suspension bottoming occuring under the worst riding conditions indicates
a good choice of spring preload.
1. Rear Springs Comfort
IMPORTANT:Make sure that all objects to be transported are in place in rear
rack and under the seat.
When driver and passenger (if applicable) take place, rear of snowmobile should
collapse by 50 to 75 mm.
Proper adjustment
A. 50 to 75 mm
Too soft of adjustment
1. Increase spring preload
To Next Page
Loading...
Need help?
General
